RC Fucking Machine 2.0

RC Fucking Machine 2.0

A motorized thrusting vibrator that does the work while you control the intensity. The adjustable suction cup mounts to smooth surfaces for hands-free use — on the floor, in the shower, against a wall. The wireless remote lets you switch between 7 vibration patterns and 3 thrusting speeds without breaking rhythm, and the travel lock prevents accidental activation in storage.

The 6.5 cm stroke length creates a back-and-forth motion that mimics manual thrusting. At the lowest speed, the movement is slow and deliberate — roughly one thrust every two seconds. The highest speed delivers rapid, shallow thrusts that intensify vibration impact. The pronounced veining along the shaft adds texture during each stroke.

This sits in the middle ground between handheld thrusters and full sex machines. You control it, but you don't have to hold it. That makes it suitable for extended sessions where grip fatigue would otherwise cut things short.

Power & Control

The motor drives both vibration and thrusting simultaneously — you can't isolate one from the other. Vibration runs through all seven modes (steady, pulsing, escalating patterns) while thrusting operates at three fixed speeds. The remote works up to approximately 10 meters with clear line of sight. Thicker walls or bathroom steam may reduce range.

USB rechargeable via the included cable. A full charge takes roughly 90 minutes and provides 45-60 minutes of combined use, depending on speed settings. The motor will slow noticeably when the battery drops below 20% — a signal to recharge rather than a sudden stop mid-session.

What's in the Box

• Thrusting vibrator with integrated shaft (non-removable)
• Adjustable suction cup base
• Wireless remote control with travel lock
• USB charging cable

The shaft is permanently attached to the motor housing. Unlike modular thrusters, you cannot swap attachments or change shaft size. If you need variety in girth or length, this isn't the right choice — consider the Body Dock Thruster series instead, which accepts interchangeable dildos.

Practical Facts

• Total length (at rest): 30.3 cm
• Total length (fully extended): 36.8 cm
• Insertable length: 15 cm
• Shaft diameter: 3.1–3.6 cm (tapered tip to base)
• Stroke length: 6.5 cm
• Weight: 323 g (vibrator only)
• Materials: Body-safe silicone shaft, ABS plastic motor housing
• Waterproof rating: IPX7 — submersible, suitable for shower use

The suction cup requires a completely smooth, non-porous surface: glass, sealed tile, acrylic shower walls. It will not hold on textured tile, painted drywall, or matte finishes. Test the grip before committing your weight to it. On vertical surfaces, the 323 g weight plus thrust force can dislodge weaker seals.

Placement & Storage

Most stable on the floor or a low bench where you can angle your body over it. Wall mounting works in a shower with proper tile, but requires more core strength to maintain position against the thrusting motion. The suction cup rotates to adjust angle, but the motor housing is fixed — you cannot tilt the entire unit independently.

For storage, release the suction cup and store flat in a drawer or case. The motor housing is 9 cm tall, so it won't fit in shallow storage. The remote is compact (approximately the size of a car key fob) and should be stored separately to avoid accidental button presses.

Noise Level

At the lowest thrusting speed with minimal vibration, it's comparable to an electric toothbrush — a low hum audible within the same room but unlikely to carry through a closed door. At the highest speed with strong vibration, the mechanical thrusting produces a rhythmic slapping sound as the motor cycles. This is similar to a handheld massager on a high setting — noticeable in adjacent rooms if the door is open or walls are thin.

The suction cup amplifies sound if mounted on a hard surface. Floor use is quieter than tile walls. Placing a towel or yoga mat underneath dampens vibration transfer.

Care & Cleaning

The silicone shaft is waterproof and can be washed with mild soap and warm water or a dedicated toy cleaner. The motor housing is splash-proof but should not be submerged beyond the shaft connection point. Dry thoroughly before storage to prevent moisture buildup in the charging port.

Use only water-based lubricant. Silicone-based lubes will degrade the shaft material over time, causing a sticky or tacky surface. If the suction cup loses grip, wash it with warm soapy water to remove oils and dust — this restores most of the original adhesion.