Autoblow 2+XT

Autoblow 2+XT

The Autoblow 2+XT simulates oral sex through motion rather than vibration. Five horizontal rows of beads inside the sleeve stroke up and down continuously, mimicking the rhythm and pressure of a mouth. You control the speed with a dial on the underside — slow and deliberate or fast and relentless. The motor is mains-powered, so sessions last as long as you want without battery fade.

This updated XT model has a stronger motor and a tighter internal fit than the original 2+. The beads move through a narrower channel, increasing contact and suction as they cycle.

The Inside Feeling

The internal sleeve is lined with five raised bead rings that move independently up and down the shaft. As the motor runs, the beads create a continuous stroking sensation — not a vibration, but a physical pull and release that mimics lips sliding along skin. The tightness comes from the sleeve itself pressing inward, not from external pressure you apply.

The sensation is most intense around the mid-shaft and head, where the bead rows concentrate. The stroking motion is consistent and mechanical — you're not controlling speed with your hand, so the rhythm stays steady even when you're close. Some users rest the unit against their thighs while lying back, letting the machine work hands-free.

The Material

The removable sleeve is made from cyber skin, a TPE material designed to feel warm and yielding against skin. It's softer than silicone and has a slight tackiness when dry — lubricant smooths this out completely. The outer casing is hard plastic, which houses the motor and bead mechanism.

Cyber skin is porous, so it will absorb lubricant and body fluids over time. This makes thorough cleaning and drying essential after every use. The material will degrade if exposed to silicone lubricants or oil-based products.

Size & Handling

The Autoblow 2+XT comes in three internal circumference sizes, measured around the tightest point inside the sleeve:

• Size A: 7.5–10 cm circumference (all lengths)
• Size B: 10–14 cm circumference (all lengths)
• Size C: 14–16 cm circumference (all lengths)

The internal sleeve depth is 17.5 cm. Length doesn't determine size — only circumference does. Choose based on your girth, not your length.

The unit weighs enough that you can rest it on your body or bed without holding it continuously. The power cable is attached to the base, so position yourself within reach of an outlet.

Cleaning & Maintenance

Pull the cyber skin sleeve out of the plastic casing after every use. Rinse the sleeve under warm running water to flush out lubricant and fluids. Do not use soap — it breaks down cyber skin and leaves a sticky residue that's nearly impossible to remove.

Spray the sleeve with a toy cleaner formulated for porous materials, or use a foam cleaner that doesn't require rinsing. Work the cleaner into all the bead ridges with your fingers, then rinse again thoroughly. Shake out excess water and pat the sleeve dry with a lint-free towel.

Let the sleeve air-dry completely — this takes several hours. Once fully dry, dust the outside lightly with cornstarch or a toy renewal powder. This keeps the cyber skin from becoming tacky and prevents it from tearing when you reinsert it into the casing.

The plastic casing can be wiped down with a damp cloth. Do not submerge it or spray water directly into the motor housing.

Store the dried sleeve separately from the casing in a breathable pouch. Cyber skin will bond to itself or other materials if left pressed together for long periods.

Lubricant

Use only water-based lubricant with the Autoblow 2+XT. Silicone and oil-based lubricants will degrade the cyber skin sleeve irreversibly. Apply lubricant generously inside the sleeve and on yourself before inserting — the bead motion creates friction, and you'll want enough lubrication to last the entire session without reapplying.